Hi Bud, thanks for the words.
If the rolling parts are the same as the 1000 frame then you will need …
cbr 600 wheels, sprocket carrier and sprocket, rear bushings made up, rear brake caliper mount from a honda earo 400, and the earo 400 twin piston rear brake calliper. The earo calliper hanger needs to be bored out to suit the 20mm axle. There maybe more on the rear and I dont know what the differences might mean because you are using the 750 fram etc.
Front end needs a set of bearings to take the front axle into the cbr front wheel (different diameter wheel hub! The speedo drive needs a 2mm skim off it and the tangs in the wheel need to be flattened out to fit it on the cbr wheel easy.
The front brakes remain the same as standard vf ( The discs and callipers are used from vf and go straight onto the cbr front) (the rear disc has to be a cbr early nineties 600 f2 same as the wheel). bushing needed at front also.
An off set front sprocket was fitted to mine which allows for a 170 tyre.
There might be more and I could not have done this without the sound knowledge and help from Bif but the end result is brill!
( you will need to check axle size as the 750 may differ)
Good luck.